5. Lower the auger control lever to lift the auger to
servicing position.
6. Release the clip on the front cover with the tool
attached to the ignition key, and lift off the cover.
7. Pull the spring handle (1) to the right out from the
spring holder to loosen the drive belt tension.
8. Hold the spring handle with your left hand and lift off
the drive belt with your right hand.
9. Put the drive belt in the belt holder (2).
10. Put the spring handle in the spring holder to prevent
that the spring falls down.
11. Lift the cutting height stay and put it in the stay
holder. (3)
12. Hold the front edge of the cutting deck with two
hands and pull forward until it stops.
13. Lift the cutting deck to vertical position until a click
sound is heard. The cutting deck is locked
automatically in the vertical position.
14.
To put the cutting deck in mowing
position
1. Hold the front edge of the cutting deck with your left
hand.
2. Loosen the lock with your right hand.
3. Fold down the cutting deck and push it in until it
stops.
63 - 007 - 20.06.2017
25
To Next Page
Loading...
Need help?
General
