Problem Cause
The battery does not charge The battery is defective. See
Battery safety on page 11
.
The connection at the cable connectors on the battery terminals is bad. See
Bat-
tery safety on page 11
.
The battery is in protective mode. See
To charge the battery on page 24
.
There is vibration in the product The collector is full. The operator has ignored the collector full signal or the sen-
sor for collector full is set in the incorrect position. See
To adjust the sensor for
collector full on page 15
.
The product is operated in long, thick and/or wet grass in non-collect mode. See
To get a good mowing result on page 18
.
The blades are loose. See
To examine the blades on page 27
.
One or more of the blades are unbalanced. See
To examine the blades on page
27
.
The auger is damaged.
The engine is loose.
The mowing result is unsatisfac-
tory
The blades are blunt. See
To replace the blades on page 27
.
The grass is long or wet. See
To get a good mowing result on page 18
.
The cutting deck is skew.
There is grass blockage in the cutting deck. See
To clean the product on page
20
.
The tire pressure is different on the right and left sides. See
To set the tire pres-
sure on page 24
.
The product is operated at a too high speed. See
To get a good mowing result
on page 18
.
The engine speed is too low. See
To get a good mowing result on page 18
.
The drive belt slips.
Transportation, storage and disposal
Transportation
• The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
• Use an approved trailer for transportation of the
product.
• Make sure that you have knowledge of local road
traffic regulations before transportation of the
product in a trailer or on roads.
To safely attach the product on a trailer for
transport
WARNING: The parking brake is not
sufficient to lock the product during
transport. Attach the product tightly to the
trailer.
Equipment: 2 approved tension belts and 4 wedge
shaped wheel blocks.
1. Apply the parking brake.
2. Attach the tension belts around the frame or rear
wagon.
3. Tighten the tension belts in the direction of the rear
and the front of the trailer to secure the product.
4. Put the wheel blocks in front of and behind the rear
wheels.
63 - 007 - 20.06.2017 31
To Next Page
Loading...
Need help?
General
