4. Attach the cover and tighten the screws.
To examine the steering wires
The tension of the steering wires can decrease after a
period of time. This causes the adjustment of the
steering to change.
Examine and adjust the steering as follows:
1. The steering wires are correctly tightened if you can
manually move them 5 mm up or down in the groove
on the steering collar.
2. If the wires are too loose, let an authorized service
agent adjust them.
To do a check of the parking brake
1. Park the product on a hard surface that slopes.
Note:
Do not park the product on a grass slope
when you do a check of the parking brake.
2. Press the parking brake pedal down (1).
3. Press and hold the lock button (2) and release the
parking brake pedal while the button is pressed.
4. If the product starts to move, let an authorized
service agent adjust the parking brake.
5. Press the parking brake pedal again to release the
parking brake.
To replace the fuel filter
1. Tilt the collector to access the fuel filter.
2. Use a pair of flat pliers to move the hose clips away
from the filter.
3. Pull off the filter from the hose ends.
4. Press the new filter into the ends of the hoses. Apply
liquid detergent to the ends of the filter to make the
connection easier.
5. Push the hose clips against the filter.
To clean and change the air filter
1. Tilt the collector to access the filter cover.
2. Loosen the knobs that hold the filter cover and lift off
the cover.
3. Lift out the air filter.
4. After 25 hours of operation, use a brush to remove
grass and dirt from the air filter and put it back. After
63 - 007 - 20.06.2017
23
To Next Page
Loading...
Need help?
General
