Page 1-4 MAXX 450D/470D/Diesel
HydraMaster Corporation
ACID RINSE AGENTS: The increased demand for “clear water” rinsing results in
the need for special care when using these acid based chemicals in your equipment.
The negative side of these products is the corrosive effects the acid can have on
metals, including swivels, pumps, heat exchangers, etc.
HydraMaster will not warranty parts that have been damaged from using unpro-
tected acid products that have obviously caused failures.
HARD WATER PROTECTION: Failure to take appropriate measures to prevent scale
build up can result in system failure and loss of warranty on affected parts. Test
the water in your immediate and surrounding areas with hard water test strips.
Assume all water obtained from wells is hard. If you are operating in a “Hard Wa-
ter Area” (3.5 grains or more per gallon), use a water softening system.
FREEZE PROTECTION: There is often little warning before a cold spell. Therefore,
not protecting this equipment from freezing will result in costly down-time. Placing
an electric heater in the truck or parking the truck indoors will help to insure against
freezing, but should not be the primary method of freeze protection.
EXHAUST SYSTEM: Do not allow flammable material (i.e. oil, fuel, plastic or wood
products) to come in contact with the exhaust system.
HOT SURFACES: During the operation of this equipment, many surfaces on the
machine will become very hot. When near the van for any reason care must be
taken not to touch any hot surface, such as heater, engine, exhaust, etc.
CAUTION
!
CAUTION
!
CAUTION
!
CAUTION
!
WARNING
!
To Next Page
Loading...