MAXX 450D/470D/Diesel Page 1-17
HydraMaster Corporation
Machine Tie Down Cleats
Secure the machine to the floor of the van with the four tie down cleats provided.
This safety measure will ensure that the machine will not slide inside the van. See
the following illustration for the correct installation.
Figure 1-3 Installation Using Tie-down Cleats
Ensure that the machine is well secured to the floor of the van with the hardware
supplied. A sudden or crash stop will cause the machine to rocket forward. Pro-
tect yourself and the machine. SECURE IT!
It is recommended by the manufacturer that the exhaust from the front of
the machine be vented down under the truck to prevent carbon monoxide
from entering the job site. Always park the truck so the exhaust is blowing
away from the job site.
The manufacturer also recommends the installation of aluminum vents in the
truck roof to allow heat to escape.
Never operate this machine with a portable gas can inside the truck. Doing
so increases the risk of a fire or explosion.
Mount a fire extinguisher just inside the rear or side door for emergencies.
WARNING
!
WARNING
!
To Next Page
Loading...