HD3070 with Automatic Gas Console Instruction Manual 5-5
16
MAINTENANCE
Starting Sequence of HD3070
On the following page is a detailed flowchart outlining the starting sequence during proper HD3070 operation.
Shaded boxes represent action taken by the operator.
The following symbols used in the flowchart are ANSI standard flowcharting symbols. Their names and definitions
are as follows:
Terminus The terminus is used to indicate the beginning
or ending point of a flowchart.
Task/Process The process or task box is used to
Box indicate any process or task other than an
input/output operation or a decision.
To Next Page
Loading...
