How to fix Hypertherm HyPerformance Plasma HPR260 pump over pressure?
If your Hypertherm Cutter is experiencing pump over pressure, verify that the coolant filters are in good condition and that there are no restrictions in the coolant system.
General| Cutting Capacity Mild Steel | 38 mm |
|---|---|
| Output Current | 30-260 A |
| Input Voltage | 200-600 V, 3-PH |
| Gas Supply | Oxygen, Air, Nitrogen |
| Duty Cycle | 260 A at 100% |
Understand potential hazards and follow instructions to avoid them.
Read and adhere to all safety messages in the manual and on the machine.
Take precautions to prevent fires and explosions during cutting operations.
Follow safety procedures to prevent fatal electric shock hazards.
Minimize exposure to toxic fumes and ensure adequate ventilation.
Use proper eye and skin protection to avoid burns from arc rays.
Ensure proper grounding of the system and workpiece for safety.
Specifies required gas quality, pressure, and flow rates for different metals.
Details on the electrical specifications and components of the power supply.
Conformance to national/local electrical and plumbing codes.
Procedures to protect the system from RFI and EMI noise.
Detailed steps for proper system grounding and cable routing.
Guide to selecting correct consumable parts for different materials and amperages.
Tips and procedures for achieving square, straight, smooth, and dross-free cuts.
Information on how error codes are displayed and where to find troubleshooting steps.
A flowchart to diagnose and resolve coolant flow issues.
Procedures for performing automatic leak tests on the gas system.
Lists initial pierce heights and delay times for bevel cutting.
To Next Page