Hypertherm Powermax 125 Field Service Bulletin

Torch Alignment Guide for Bevel Cutting
8 811280 Field Service Bulletin Powermax125 / MAXPRO200
13. Move the torch alignment guide so that the correct torch clearance gauge is in front of the
torch.
 One torch clearance gauge is for Air/Air processes. The other gauge is for O
2
/Air
processes (MAXPRO200 only). Refer to Figure 1 on page 4.
 Make sure that you keep the torch alignment guide on the edge of the workpiece .
3
4
3
4

Hypertherm Powermax 125 Specifications

General

Output Current	30-125 A
Input Power	15.2 kW
Open Circuit Voltage	300 VDC
Gas Supply	Clean, dry, oil-free air or nitrogen
Input Power Cable Length	10 ft (3 m)
Rated Output Current	125 A
Gas Type	Air or nitrogen
Cutting Capacity	1-1/4 inch (32 mm)
Pierce Capacity	1 inch (25 mm)
Input Voltage	200-600 V, 3-PH
Duty Cycle	100% @ 125 A
Certifications	CSA
Maximum Clean Cut Thickness	1-1/4 inch (32 mm)
Cooling Method	Fan-cooled
Torch Options	Hand