www.hysecurity.com © 2019 Display & Menu Options MX3630-01 Rev. J 59
User Menu Setting Options Menu Tasks & Explanations STC Wire
Connections
PD 0
SET PASSWORD
0 = Off
1 = On (Set Password)
NOTE: A System Address (SA) value in the installer
Menu must be set before the Set Password display
appears in the User Menu.
To enter a password (up to 80 characters) for
network connectivity, select 1. You can use the menu
navigation buttons to enter the password. When the
password is set, the display returns to the 0 setting.
Network: Ethernet or
RS-485
HyNet conguration
Installer Menu
The Installer Menu options provide more advanced congurations for the gate
operators. Access to the Installer Menu is through the User Menu. The navigational
buttons are the same in both menu modes. Refer to Menu Mode Navigation on page
53.
Access:
While a static gate status is being displayed, press the Menu button twice. (Bypasses
the operator status displays.)
When the Close Timer display appears (Hold to Close, if the Close Timer display is
hidden):
1. Access the Installer Menu by simultaneously pressing and holding the Reset
and Open buttons.
2. Release both buttons and the display changes, indicating you have arrived at
the rst item in the Installer Menu.
NOTE: Installer Menu options can also be congured through the use of a laptop
computer and S.T.A.R.T. software. See Smart Touch Analyze and Retrieve Tool
information found on the HySecurity website: www.hysecurity.com
Table 6: Installer Menu on page 59 describes the Installer Menu items and supplies
the factory defaults. (Factory settings shown in bold.)
Table 6: Installer Menu
CT 0 (OFF)
CLOSE TIMER
HYSECURITY
GATE STOPPED
UC 2
USAGE CLASS
To Next Page
Loading...
Need help?
General
