Hyster B60Z - Troubleshooting Guide; Lift Assemblies Issues

Troubleshooting 1900 SRM 964
Troubleshooting
LIFT ASSEMBLIES
PROBLEM POSSIBLE CAUSE PROCEDURE OR ACTION
Forks fail to elevate. Oil in the hydraulic reservoir is low. Fill reservoir to correct level. Check
for leaks.
Faulty hydraulic equipment. See Lift Pump and Motor Assembly,
and Lift Cylinders below.
Broken pull rods. Disassemble and replace damaged
parts.
Deformed lifting components. Disassemble and replace damaged
parts.
Slow lifting speed and insuf-
ficient handling capacity.
Oil in the hydraulic reservoir is low. Fill reservoir to correct level. Check
for leaks.
Faulty hydraulic equipment. See Lift Pump and Motor Assembly,
and Lift Cylinders below.
Deformed lifting components. Disassemble and replace damaged
parts.
Forks fa
il to lower.
Deforme
dforks.
Disasse
mble, repair, or replace.
Deforme
d lifting components.
Disasse
mble, repair, or replace.
Bent li
ft cylinder piston rod.
See Lif
t Pump and Motor Assembly,
and Lif
t Cylinders below.
26