EasyManua.ls Logo

Hyster D187 - Gauges, Indicator Lights, Horn, Fuses, and Relays

Hyster D187
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8000 SRM 707 Maintenance Procedures Every 8 Hours or Daily
Gauges, Indicator Lights, Horn, Fuses,
and Relays
Check operation of horn. Turn key switch to ON posi-
tion. Check all gauges and indicator lights for correct
operation as described in the Operating Manual.
Start engine. If any indicator lights or gauges do not
operate correctly, check fuses. The fuses are under
the instrument panel on the left side of the cowl. See
Figure 14. On newer lift truck models with the emis-
sions compliant GM 3.0L engine, there are additional
fuses and relays located in the engine compartment.
SeeFigure15.
NOTE: THERE IS ALSO A 50-AMP ALTERNATOR FUSE NEAR THE ALTERNATOR. SOME UNITS ALSO HAVE
A RELAY NEAR THE BATTERY.
1. TRANSMISSION SOLENOIDS (5 AMP)
2. HORN (10 AMP)
3. GLOW PLUG RELAY, DIESEL (30 AMP)
4. LIGHTS (25 AMP)
5. TURN SIGNALS/BRAKE LIGHTS (10 AMP)
6. LIGHTS (30 AMP)
7. INSTRUMENT CLUSTER (30 AMP)
8. HEATER
9. FRONT WIPER
10. REAR WIPER
11. HORN RELAY
12. LIGHT RELAY
13. TURN SIGNAL RELAY
14. REAR LIGHT RELAY
15. ACCESSORY RELAY
Figure 14. Fuses and Relays
29

Table of Contents

Other manuals for Hyster D187

Related product manuals