EasyManua.ls Logo

Hyster D187 - Hydraulic System; Air Filter; How to Make Checks with Engine Running

Hyster D187
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance Procedures Every 8 Hours or Daily 8000 SRM 707
Hydraulic System
Check hydraulic system for leaks and damaged or
loosecomponents. SeeFigure12.
1. HYDRAULIC TANK DIPSTICK
Figure 12. Hydraulic System Oil
Air Filter
There is an indicator light on the instrument clus-
ter for the air filter. The red light is on when the
keyswitchisintheSTART position and must go off
when the engine is running. If the light is on when
the engine is running, the air filter has a restriction
and needs cleaning.
WARNING
Compressed air can move particles so they
cause injury to the user or to other personnel.
Make sure the path of the compressed air is
away from all personnel. Wear protective gog-
gles or a face shield to prevent injury to the
eyes.
Clean or install new air filter as necessary. Use com-
pressed air to clean filter element. See Figure 13. Air
pressure must be less than 210 kPa (30 psi). Apply
air from inside to outside of filter element.
WARNING
Cleani
ng solvents can be flammable and toxic
and can
cause skin irritation. When using
clean
ing solvents, always follow the recom-
menda
tions of the manufacturer.
Inspect filter element. Put a bright light inside filter
element and look for holes or other damage. If the
filter element is damaged, install new filter element.
Useaclothwithsolventtocleaninsideofcanister
when filter element is installed.
1. CANISTER
2. FILTER ELEMENT
3. SEAL
4. CLAMP
5. WING NUT
6. BAFFLE
7. END COVER
Figure 13. Air Filter
HOW TO MAKE CHECKS WITH ENGINE
RUNNING
WARNING
Do not operate a lift truck that needs repairs.
Report the need for repairs immediately. If re-
pair is necessary, put a DO NOT OPERATE tag
in the operator’s area. Remove the key from
the key switch.
WARNING
FASTEN YOUR SEAT BELT! The seat belt is in-
stalled to help the operator stay on the truck if
the lift truck tips over. IT CAN ONLY HELP IF
IT IS FASTENED.
Make sure the area around lift truck is clear before
starting engine or making any checks of the opera-
tion. Be careful when making checks. If the lift truck
is stationary during a check, apply parking brake
and put transmission in NEUTRAL.Makechecks
carefully.
28

Table of Contents

Other manuals for Hyster D187

Related product manuals