Hytera DMR System Planner
136
For example, you can deploy multiple repeaters in a large building to ensure
seamless communication. This can help fight the problems from unfavorable
terrains.
3) To broadcast a message to all connected repeaters.
For example, the dispatcher can send an instruction to all repeaters in IP Multi-site
Connect mode in case of an emergency.
4) To connect repeaters working with varied frequency bands.
For example, UHF repeaters and VHF repeaters can be connected so that data and
voice can be exchanged among them.
5) To use multiple IP-based applications.
For example, when IP Multi-site Connect is enabled, you can use multiple
IP-based software (such as Dispatcher) as well as API-based software developed
by any third party to realize more functions.
* Consult your dealer for more information on supported software.
* Consult your dealer for more information on development of API-based software.
Requirements on Network：
1) The IP network can either be a dedicated network or an internet provided by
Internet Service Provider (ISP).
2) A number of technologies are supported by the ISPs, including dial-up, xDSL,
cable modem, broadband wireless access, canopy, ISDN, satellite internet access,
and so on. Currently, the IP network is not applicable to dial-up connection due to
narrow bandwidth or satellite internet access due to large delay.
3) Sufficient bandwidth is required for IP network.
4) In IP network, there must be a static IP address and UDP port for Master repeater
and Slave repeater. For the latter, it is unnecessary to fix its IP address and UDP
port.
5) The repeater can locate behind the firewall, router or NAT.
6) IP address instead of proxy server shall be used to access the WAN.
To Next Page
Loading...
Need help?
General
