Hytera DMR System Planner
33
2.5.4 Lone Worker
Lone Worker emergency is used to ensure your safety. You can set a time period for
your radio. If no keypad operation is made on the radio within this period, the radio
will trigger the emergency alarm automatically. This feature is designed for people
(such as police, firefighters, miners, etc.) in dangerous workplaces.
With this feature, the radio will automatically transmit an alarm to alert the related
users when you are in danger and fail to take any actions.
Lone Worker is a timed emergency feature. Within the preset Lone Worker
Response Time, if there is not any operation on the radio keypad, the radio will
transmit an emergency alarm to inform the related users that you are in danger. If
you operate the radio within the preset time, the radio will not transmit the alarm,
and the Lone Worker Response Time will be counted from the beginning again.
There may be mistaken alarm in actual use, so another feature is added: Lone
Worker Remind Time. In the preset period, the left Lone Worker Response Time,
before the Emergency mode is initiated, the radio will remind you that the alarm is
due. If you are safe, you can have any key operation to relieve the radio from alarm.
You can define the Lone Worker feature, as well as the Lone Worker Response
Time and Lone Worker Remind Time under the feature, via the CPS only. If you
want to activate or inactivate the feature through the radio, you must select “Lone
Worker” option in “Menu” in the CPS. You can assign the programmable key with
Lone Worker feature, so you can activate or inactivate the feature by pressing the
key. Besides, you can also set the Lone Worker feature to be activated automatically
via the CPS. You can use any of the aforesaid three ways to activate this feature.
To Next Page
Loading...
Need help?
General
