Hytera DMR System Planner
35
As the Man Down feature is more sensitive and timely to send emergency alarms, it
should be used in appropriate occasions and defined reasonably. To use this feature,
you need to configure its parameters via the CPS. The Trig Entry Delay Time is used
to set the time period for activating the emergency alarm. You should set it based on
actual requirements. In very dangerous place, you need to set the time shorter so
the radio will be more sensitive for alarm triggering. You can also set the Trig Exit
Delay Time to define the time period before which the emergency mode is quited.
Like the Lone Worker feature, Man Down is also an expanded emergency feature.
You can configure this feature via the CPS only. If you want to activate or inactivate
the feature through the radio, you must select “Man Down” option in “Menu” in the
CPS. You can assign the programmable key with Man Down feature, so you can
activate or inactivate the feature by pressing the key. Besides, you can also set the
feature to be activated automatically via the CPS. You can use any of the aforesaid
three ways to activate this feature.
Man down Process:
Figure 2.5.5-1: Man Down Process
To Next Page
Loading...
Need help?
General
