• DO NOT attempt to charge the battery pack with any chargers other than the one in this
manual. The charger and battery pack are specically designed to work together.
• These chargers are not intended for any uses other than batteries supplied with Lithium
series guns as described in this manual. Any other uses may result in risk of re, electric shock
or electrocution.
• Do not expose charger to rain or snow.
• To disconnect charger, firmly grasp plug and remove. Do not disconnect the charger by pull-
ing on the cord.
• Make sure the cord is located so that it will not be stepped on, tripped over, or otherwise
subjected to damage or stress.
• Do not use an extension cord unless it is absolutely necessary.
• An extension cord must have adequate wire size (AWG) for safety. In general the larger the
wire size the greater the capacity of the cable.
• Do not block any ventilation slots on charger power supply.
• Do not mount charger on wall or permanently fix charger to any surface. The charger is in-
tended to be used on a at surface (i.e. table top, bench top).
• Do not operate charger with damaged cord or plug. Have any damaged plug or cord replaced
immediately.
• Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged
in any way.
• Do not disassemble charger; take it to an authorized Torque Gun service center when ser-
vice or repair is required.
• This charger is designed to operate on standard household electrical power (120V/220V
60hz/50hz).
17
BREAKTHROUGH PRODUCTS FOR INDUSTRIAL BOLTING
To Next Page
Loading...
Need help?
General
