Tightening with HYTORC Washer
• Put the tool in tightening mode.
• Put the tool in HYTORC Washer mode (Refer to the Options section)
• Place the HYTORC Washer Driver on the battery powered tool and tighten the set screw.
• Engage the HYTORC Washer Driver and tool with the nut by placing it over the top of the bolt to
be tightened.
• Repeat the steps for tightening a bolt as shown for standard torque in this manual.
32
BREAKTHROUGH PRODUCTS FOR INDUSTRIAL BOLTING
Figure 19 - HYTORC Washer Driver on LITHIUM
To Next Page
Loading...
