The US Department of Transportation Hazardous Materials Regulations (HMR)
actually prohibit transporting batteries in commerce or on airplanes, (i.e. packed
in suitcases and carry-on luggage). When transporting individual batteries, make
sure that the battery terminals are protected and well insulated from materials that
could contact them and cause a short circuit. For any other concerns in regarding the
transportation of LI-ION batteries, consult your Transportation Carrier.
THE RBRC
TM
SEAL
The RBRC
TM
(Rechargeable Battery Recycling Corporation) Seal on the lithium ion battery (or battery
pack) indicates that the costs to recycle the battery (or battery pack) at the end of its useful life have
already been paid by HYTORC.
The RBRC
TM
in cooperation with HYTORC and other battery users, has established programs in the
United States to facilitate the collection of spent lithium ion batteries. Help protect our environment and
conserve natural resources by returning the spent lithium ion battery to an authorized HYTORC service
center for recycling. You may also contact your local recycling center for information on where to drop
off the spent battery. RBRC
TM
is a registered trademark of the Rechargeable Battery Recycling Corpora-
tion.
IMPORTANT BATTERY CHARGER SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS: This manual contains important safety instructions for battery chargers:
• Before using charger, read all instructions and cautionary markings on charger, battery pack and
product using battery pack.
WARNING: Shock hazard. Do not allow any liquid to get inside charger.
CAUTION: Burn Hazard. To reduce the risk of injury, charge only Torque Gun batteries.
Other types of batteries may burst causing personal injury and damage.
CAUTION: Under certain conditions, with the charger plugged into the power supply, the
charger can be shorted by foreign material. Foreign materials of a conductive nature such
as, but not limited to, steel wool, aluminium foil, or any buildup of metallic particles should
be kept away from charger cavities. Always unplug the charger from the power supply
when there is no battery pack in the cavity. Unplug charger before attempting to clean.
16
BREAKTHROUGH PRODUCTS FOR INDUSTRIAL BOLTING
To Next Page
Loading...
Need help?
General
