IAI MSCON - Page 229

3.9 About Gateway Parameter Setting Tool
221
3) GW mode Select
• Enable SW : Select whether to activate/inactivate the enable switch in
TP.
• BYTE swap : Set the byte swap. [Refer to 3)-1 in this section.]
• WORD swap in D-WORD Data : Set whether to swap the W-word sized data with word size.
[Refer to 3)-2 in this section.]
• Enable SW in AUTO mode : Select whether to activate/inactivate the enable switch in
AUTO mode.
3)-1 BYTE swap: Swap the upper and lower in the sent and received data in byte unit. Set
this considering the connected host system if necessary.
● = ON, ○ = OFF
MSEP
ON/OFF
ON/OFF
ON/OFF
ON/OFF
入力
レジスタ
16進
データ
16進
データ
16進
データ
16進
データ
MSEP
RWwnn
PLC：
RWrnn
出力
レジスタ
MSCON
Input
register
MSCON
Output
register
Hexadecimal
data
Hexadecimal
data
Hexadecimal
data
Hexadecimal
data
ME0306-2A