IAI MSCON - Page 228

3.9 About Gateway Parameter Setting Tool
220
3.9.3 Description of Functions
1) GW-Param
• Latch in ERR_T/C : Select whether to continue the error even in
recoverable condition after ERRT and ERRC are
issued.
• SERVO-OFF in ERR_C : Select whether to turn the servo OFF on the
connected axes when ERRC is occurred.
• unit velocity (Only Direct Indication Mode) : Select the unit for speed from 1.0mm/s and
0.1mm/s.
• Internal communication retry count : Set the number of communication retries with
the connected axes in AUTO mode.
2) GW-Param 2
• Fan round monitor : Select whether to/not to monitor the fan rotation speed with the monitor
function.
• RTC function : Select whether to generate alarm when clock setting is lost.
ME0306-2A