IAI MSCON - Page 67

Chapter 2 Wiring
59
4) CompoNet Type
CompoNet Connector Model Remarks
Cable Side
Connector that
complies with
CompoNet standards
Please prepare separately
Controller Side XW7D-PB4-R Manufactured by OMRON
Pin
No.
Signal Name
(Color)
Contents Applicable Cable
1 BS+ (RD)
Communication Power
Supply +
(Note 1)
2 BDH (WT) Signal Cable H Side
3 BDL (BL) Signal Cable L Side
4 BS- (BK)
Communication Power
Supply -
(Note 1)
CompoNet
Dedicated Cable
Note 1: It is unnecessary to supply the communication power. (Internal
power source is used.)
If conducting multi power supply to other slave devices via
communication cables, there is no problem with connecting the
power supply to BS+ and BS- terminals.
(Note): Connect a terminal resistor (121Ω) between BDH and BDL to
the end of the network. [Refer to 2.2 [8] Field network Circuit
(For Field network Type)]
5) EtherNet/IP Type
EtherNet/IP Connector Model Remarks
Cable Side 8P8C Modular Plug
Controller Side 8P8C Modular Jack
Pin No.
Signal Name
(Color)
Contents Applicable Cable
1 TD+ Sent data +
2 TD- Sent data -
3 RD+ Received data +
4 ― Not used
5 ― Not used
6 RD- Received data -
7 ― Not used
8 ― Not used
For EtherNet cable,
use a straight STP
cable that
possesses the
performance of
Category 5e or
more.
Front view of
connector on
controller side
1
2
3
4
Front view of
connector on
controller side
BK (BS-)
BL (BDL)
RD (BS+)
WT (BDH)
8
1
ME0306-2A