IAI MSCON - Page 91

3.4 Fieldbus Type Address Map
83
[Combination Example 3] When number of Simple Direct Mode axes is 0 and number of Direct
Indication Mode 6
(Extended Cyclic Setting/Number of Occupied Stations: 8 times/2
stations)
PLC→MSCON MSCON→PLC
Address Contents Address Contents
RY 000 to 01F Gateway Control RX 000 to 01F Gateway Status
RY 020 to 06F
Demand
Command
RX 020 to 06F
Response
Command
RY 070 to 07F Unavailable RX 070 to 07F Unavailable
RY 080 to 17F Unavailable RX 080 to 17F Unavailable
RWw 00 to 03
Axis No.0 Control
Information
RWr 00 to 03
Axis No.0 Status
Information
RWw 04 to 07 RWr 04 to 07
RWw 08 to 0B
Axis No.1 Control
Information
RWr 08 to 0B
Axis No.1 Status
Information
RWw 0C to 0F RWr 0C to 0F
RWw 10 to 13
Axis No.2 Control
Information
RWr 10 to 13
Axis No.2 Status
Information
RWw 14 to 17 RWr 14 to 17
RWw 18 to 1B
Axis No.3 Control
Information
RWr 18 to 1B
Axis No.3 Status
Information
RWw 1C to 1F RWr 1C to 1F
RWw 20 to 23
Axis No.4 Control
Information
RWr 20 to 23
Axis No.4 Status
Information
RWw 24 to 27 RWr 24 to 27
RWw 28 to 2B
Axis No.5 Control
Information
RWr 28 to 2B
Axis No.5 Status
Information
RWw 2C to 2F RWr 2C to 2F
3) PROFIBUS-DP, EtherNet/IP, EtherCAT
[Combination Example 1] When number of Simple Direct Mode axes is 4 and number of Direct
Indication Mode 0
(n is the top channel number for each PLC input and output between
MSCON and PLC)
PLC→MSCON MSCON→PLC
Node address
(Byte Address)
Contents
Node address
(Byte Address)
Contents
n to n+3 Gateway Control n to n+3 Gateway Status
n+4 to n+15
Demand
Command
n+4 to n+15
Response
Command
n+16 to n+23
Axis No.0 Control
Information
n+16 to n+23
Axis No.0 Status
Information
n+24 to n+31
Axis No.1 Control
Information
n+24 to n+31
Axis No.1 Status
Information
n+32 to n+39
Axis No.2 Control
Information
n+32 to n+39
Axis No.2 Status
Information
n+40 to n+47
Axis No.3 Control
Information
n+40 to n+47
Axis No.3 Status
Information
ME0306-2A