62
Table 2-1 BIOS Error Codes, Messages, and Beeps List
BIOS Error Codes,
Messages, Beeps
Action/FRU
NOTE: To diagnose a problem, first find the BIOS error
messages, codes, or beeps in left column. If directed to a
check procedure, replace the FRU indicated in the check
procedure. If no check procedure is indicated, the first
Action/FRU listed in right column is the most likely cause.
1701
Hard disk(s)
Diagnosis failure
Make sure the hard disks are set
correctly in BIOS setup.
Hard disk drive cable/connection.
Hard disk drive.
System board.
1762
Primary master IDE
has changed
Primary slave IDE has
changed
Secondary master
IDE has changed
Secondary slave IDE
has changed
Make sure that the System Boot Drive
parameter in the Startup Options of
BIOS Setup is not set to [Drive A only].
Load default settings in Setup.
Insert a system diskette into diskette
drive and reboot system.
Make sure the diskette drive
configuration setting in BIOS Setup is
correct.
Hard disk drive power.
Diskette drive.
System board.
1780
Primary master hard
disk failure
1781
Primary slave hard
disk failure
A warning message to indicate there
has been change of IDE Primary
(Secondary) Channel Master (Slave)
device.
Load default settings in Setup.
Check IDE drive jumper. See “3.5-In.
Hard Disk Drive Jumper Locations” on
page 141.
IDE drive power.
IDE drive cable/connection.
IDE drive.
To Next Page
Loading...
Need help?
General