63
Table 2-1 BIOS Error Codes, Messages, and Beeps List
BIOS Error Codes,
Messages, Beeps
Action/FRU
NOTE: To diagnose a problem, first find the BIOS error
messages, codes, or beeps in left column. If directed to a
check procedure, replace the FRU indicated in the check
procedure. If no check procedure is indicated, the first
Action/FRU listed in right column is the most likely cause.
1782
Secondary master
hard disk failure
1783
Secondary slave hard
disk failure
A warning message to indicate there
has been change of IDE Primary
(Secondary) Channel Master (Slave)
device.
Load default settings in Setup.
Check IDE drive jumper. See “3.5-In.
Hard Disk Drive Jumper Locations” on
page 141.
IDE drive power.
IDE drive cable/connection.
IDE drive.
8602
Mouse error on no
Mouse present
Make sure the Mouse is connected
properly and are set correctly in BIOS
Setup.
Mouse.
System board.
SYSTEM HALTED,
(CTRL-ALT-DEL) TO
REBOOT…
Indicates the present boot attempt has
been aborted and the system must be
rebooted. Press and hold down the
CTRL and ALT key and DEL.
Hard Disk(s) failure
(80)
Hard Disk Drive reset failed.
Hard Disk(s) failure
(40)
Hard Disk Drive controller diagnostics
failed.
Hard Disk(s) failure
(20)
Hard Disk Drive initialization error.
Hard Disk(s) failure
(10)
Unable to recalibrate fixed disk.
To Next Page
Loading...
Need help?
General