)( .-f-+ -Go Elsewhere
This message appears
if
you try
to
take an action in the wrong location, such as:
• To enter, insert, erase, or delete a character when the cursor
is
in a protected
field.
• To read a magnetic stripe when the cursor
is
in a protected field.
• To perform a cursor select operation when the cursor
is
not in a valid cursor
select field (refer to
CURSR SEL key description in the keyboard sections).
Press the RESET key to restore your keyboard; then move the cursor to another
location or take a different action.
)( f > -Too Much Data
This message appears
if
you try to enter more data into a field than
it
can hold.
Press the RESET key
to
restore your keyboard; then correct the en try.
)( f
f'"0~
U r
o
,ol
- Numeric Data Only
This message appears
if
you try to enter a non-numeric character (other than
0-9, .,
-,
or DUP) into a numeric field. Press the RESET key
to
restore your
keyboard; then enter numeric data. To override the numeric control,
use
1}
or
~
(~
key
is
present on Data Entry keyboards only).
)(
fU1' -What Number?
This message tells you
that
only certain numbers can
be
entered for the operation
you are performing. For example, this message is displayed when you:
• Enter an invalid Printer ID or Printer
Class
during a print operation (refer to
IDENT key description in the keyboard sections)
• Make an error when your display station
is
in test mode (follow test instruc-
tions in the Problem Determination Guide)
Press the RESET key to restore your keyboard; then enter the correct number.
2-22
To Next Page
Loading...
