)(
PROGnnor
)(
PROGnnn
-Program Check
This message means the control unit detected a programming error in the data
it received from the host system. The error number, nn or nnn, defines the
type
of
Program Check. Press the RESET key to restore your keyboard, and
continue.
If
the problem persists, refer to your Problem Determination Guide
to determine the appropriate action.
)(
c:J--Cl.»
Printer
Busy
The
)(
Cl-Cl.:.;
..
::.
message means the printer connected to your display station
is
busy and carinot perform the print operation you requested.
If
~
is
dis-
played in the Printer Status
Message
Area to the right, the printer
is
busy per-
forming your own print operation;
if
o-c::J
is
displayed in the Printer Status
Message
Area, the printer
is
busy performing an operation for another display
station or the host system.
If
you initiated the print operation by using the
CHl
key, you can either
(1) wait for the print operation to fmish or (2) press the
DEV
CNCL
key to
cancel the operation.
If
you cancel the operation and
o-c::J
is
displayed you
may
be
able to select another printer using the IDENT procedure and restart the
print operation by using the
CHl
key.
If
the print operation
was
initiated by the host system (via a P A key, the ENTER
key, etc.), you can cancel the print operation by pressing the
DEV
CNCL
key.
However,
if
the host system initiates the same print operation again, you should
either
(1) wait for the print operation to finish or (2) wait for the host system
to restore your keyboard.
The
RESET key has no effect when this message
is
displayed.
)(
r::::J-Cl.):
..
):. -Printer Very
Busy
This message means the same thing
as
the)(
CJ---CJ.:
(.
(printer Busy) message,
except that more time
is
anticipated before your print operation
is
accepted.
)(
~
- Printer Not Working
The)(
~
message means the printer connected
to
your display station
is
not
working (out
of
order, unplugged, out
of
paper, etc.) and cannot perform the
print operation you requested. Therefore, your print request
was
canceled.
If
you initiated the print operation by using the
CHl
key, you should press
the
DEV CNCL key to restore the keyboard. Your print request
was
canceled.
You may then select a different printer using the IDENT procedure, try to
restore the failing printer, or take other action.
If
~
is
displayed in the Printer Status
Message
Area to the right, the printer
stopped working while printing your own last print operation.
If
the print operation
was
initiated by the host system (via a
PA
key, the ENTER
key, etc.), you can cancel the print operation by pressing the
DEV
CNCL
key.
The
RESET key has no effect when this message
is
displayed.
2-24
To Next Page
Loading...
Need help?
General
