(
(
(
(~
(
(
Installing
the
5103
Printer
Stacker
A folded-form paper stacker
is
supplied with 5103 printers. The wire stacker hooks
onto the back of the printer cover
as
shown
in
the drawing. The lower wires on the
stacker should contact the metal clips on the cover.
The stacker can be bent
if
too
much weight
is
applied. Under normal conditions,
printed forms should
not
be
allowed
to
accumulate higher than 1 inch
in
the
stacker.
Note that, because of the relatively small free-fall dist.ance of the paper
as
it leaves
the printer, you may have
to
manually fold the first two or three sheets
to
get the
folding operation started.
167
To Next Page
Loading...
Need help?
General