30
RENUM
[KEYxl
[,first
line-num,incrementl
RENUM COMMAND
You can use
the
RENUM (renumber) command
to
generate new statement numbers
for
all
the
BASIC statements
or
data
in
the work area. Like the AUTO command,
renumbering begins with
0010
and the increment
is
10, unless specified otherwise.
In
addition,
all
references
to
statement numbers
in
GOTO, I F, PRINT USING,
GOSUB, GET, and
MAT
GET statements are changed
to
the
new numbers.
In
function key groups (see
LOAD
Command), each key group
is
renumbered
as
if it
is
a separate work area, and
is
only renumbered
if
it
is
a BASIC program function.
(RENUM does
not
alter
the
key group header record.)
The syntax
of
the
RENUM command
is
as
shown:
RENUM
[KEYxl
[,first
line-num,incrementl
where:
KEYx specifies a key group
(x
= 0
to
9)
to
be renumbered.
first line-num
is
an integer (1-9989) identifying
the
number
at
which renumbering
will begin. If this number
is
not
specified, a beginning number
of
0010
and an
increment
of
10
are
the
default values.
increment
is
an integer specifying the increment for succeeding
statement
numbers.
If a beginning
statement
number
is
not
specified, an increment cannot be specified.
Notes
About
RENUM
• You must enter both a beginning statement number and increment,
or
you can
enter neither.
• Statement numbers 9990-9999 are
not
altered
by.
a RENUM command.
• An error will occur
if
you
try
to
renumber where a line number greater than
9989
will be generated.
./
To Next Page
Loading...
