IBM 6360 User Manual

REMOVALS/REPLACEMENTS
Cover Removal
1. Turn the system power off.
2. On early level machines, remove
two screws in the back of the mod-
ule. On later level machines,
release the two quarter-turn
- fasteners 0 .
3. Slide the top cover to the rear.
4. Remove four screws holding the
front cover •.
5. Slide the front cover forward.
~'~--- I.'~
I ~I
I
I
~
Head Load Bail Removal
CAUTION
When a diskette drive is removed from
its mounting, verify the ground
through the AC connector. Check
for 0 ohms between the diskette unit
base and the diskette drive.
1. Turn the system power off.
2. Close the diskette handle.
3. Disconnect the bail actuator cable
from the bail cable stud I).
4. Open the handle.
WARNING: Damage to the head
can occur if the pressure pad arm
is permitted to h it the head.
5. Observe the position of the bail
return spring • and loosen the
bail screw. and pivot the bail
retainer down G.
6. Remove the bail, bail return
spring, and pivot rod.
() I
l
.@~
O"@
7-32 IBM Displaywriter Product Support Manual

IBM 6360 Specifications

General

Brand	IBM
Model	6360
Category	Desktop
Language	English