IBM 6360

SECTION 14. BAT FAILURES
Pre-CRT I nitialization BAT Failures
Check the following:
•
DC supply voltages.
•
AC input voltage.
•
Reseat
all
electronic cards and
check all connectors inside the
Electronics Module.
•
Reseat the Display Module connec-
tor 2.
Post-CRT Initialization BAT Failures
Check the following:
• DC supply voltages.
•
•
•
•
•
•
•
•
AC input voltage.
Reseat all electronic
check all connectors
Electronics Module.
cards and
inside the
Reseat the Display Module connec-
tor 2.
Reseat the keyboard logic card and
the diskette adapter card.
Check the keyboard logic card con-
nector and the keyboard cable con-
nector 7.
Check all connectors
Diskette Unit.
on the
Check panel 1, connectors 5, 8.
Check panel 2, connector 10.
Chapter 10. Intermittent Problem Diagnostic Approach 10-21