IBM 6360 User Manual

C.E. 'Diagno.stics • ,>.IP,is K~y.~~~ard
CED20'lJ, ". •
~Iemory xxxx
Kyb.xxx·
Section - 10
Subsection - 70
CANCL to return to Device Selection;
END to return to Function Selection.
Type y ,n, (b,o, t,r) ;,press ENTER:
Step - ODS
~Iode - Step
Figure 9-19. Question Prompt
•
Command Test Prompt. The follow-
.ing is displayed when command text
is. sp.ecified with an MDI step.
Command text gives instructions
which must be performed before
continuing with MDI.. If one of
the options (b,o, t, r) is
entered, that option is taken. If
no option is entered, the MDI will
continue with the next step. When·
ENTER is pressed, the MOl ,con1:;rol-
ler looks .at the response and
takes the needed .action
(Figure 9-20).
C.E. Diagnostics ~WIs· Keyboard ~lodu1e
CED201 .
In order to 'check' the ~lake/Break Key.
codes a given sequence must be
follOl,·ed. As an aid to the Operator
conducting the test, the next Key in
the sequence appears BLHiKING on the
screen.
The Shift Lock must be up before
starting the test.
CANCL to return to Device Selection;
E!'iD to return to Function 'Se lection.
Type (b,o,t,r); press EII'TER:
~Ieniory xxxx
. Kyb xxx
Section. - 10
Subsection - 70
Step - DOS
. Mode " ·-Step
Figure 9-20. Command Test Prompt
•
Test Unit Prompt. One of the fol-
lowing is displayed when a step. is
run in the step mode
(Figure 9-21). The results of the
test unit are checked, and a deci-
sion is' made by the' MDI
controller. This may be overriden
by entering another value or one
of the other options (b,o,t,r).
When ENTER is pressed, the MDI
controller looks at the response
and takes the needed actions.
9-26 IBM Displaywriter Product Support Manual

IBM 6360 Specifications

General

Brand	IBM
Model	6360
Category	Desktop
Language	English