2. Toggle the Action field by using the Spacebar to select Update.
3. Type in the user’s name in the Username field for the user account that you
want to change; then, press Enter. Type in the old password in the Old
Password field for that user account; then, press Enter.
4. You can now modify the password or the privilege level for this user account.
v To change the password, type in the New Password that you have chosen,
and press Enter. Type in the same new password in the Confirm New
Password field to verify that you have not mistyped it.
v To change the privilege level, toggle the Access Level field until the
appropriate level is displayed - Root, User+,orUser.
5. Highlight APPLY and press Enter to make the change effective.
6. You must enter the configuration changes into the NVRAM through the Save
Changes choice on the main menu if you want the configuration to be used
after a switch restart.
Deleting a user account
Only a user with Root privileges can delete user accounts. Before you can delete a
user account, you must also enter the password for that user account.
Complete the following steps to delete a user account and password:
1. Select Setup User Accounts in the main menu. The following Setup User
Accounts window opens.
2. Toggle the Action field to Delete.
3. Enter the applicable information in the Username and Old Password fields for
the account that you want to delete.
Chapter 6. Configuring the switch module through the Telnet interface 83
To Next Page
Loading...
