To restart the switch, in the mode entered in the preceding window, highlight Yes
and press Enter.
Logging out
When you are finished with the current switch-module session, select Logout from
the main menu. You can select one of two methods for processing the changes that
you made during the current switch-module session:
v If you made changes and used the APPLY function during the current
switch-module session, but did not save your changes on the main menu, the
following window will open:
If you do not want to save your changes, select Yes to log out without saving
your changes. The current switch-module session will close and, the login
window will open so that you can start a new switch-module session (see
“First-time connection to the Ethernet switch module” on page 76 for additional
information).
v If you either saved your changes on the main menu or did not make any
changes during the current switch-module session, the Logout window will not
open when you select Logout. Instead, the current switch-module session will
immediately close and, the Login window will open so that you can start a new
switch-module session (see “First-time connection to the Ethernet switch module”
on page 76 for additional information).
98 IBM BladeCenter 4-Port Gb Ethernet Switch Module: Installation and User’s Guide
To Next Page
Loading...
