IP Address
The IP address of the network management station to receive traps.
SNMP Community String
The community string that will be included on SNMP packets sent to and
from the switch. Any station that is not a member of this community will not
receive the packet.
Status
Determines whether this community name entry is Enabled or Disabled.
Highlight APPLY and press Enter to make your changes effective.
Switch Settings
Highlight Switch Settings in the main menu and press Enter to set GVRP globally,
enable the MAC address aging timer, and to set the upper threshold of the storm
control.
The user-changeable parameters in the switch are as follows:
Switch GVRP <Disabled>
Group VLAN Registration Protocol is a protocol that enables members to
dynamically join VLANs. This option is used to enable or disable GVRP on
the switch module.
MAC Address Aging Timer <Enabled>
This field specifies whether the aging timer is on or off.
MAC Address Aging Time(sec) [300]
The aging timer of MAC address entries can be set from 10 to 1000000
seconds.
Telnet Settings
The user-changeable parameters in the switch are as follows:
Telnet Time Out (min) <10 mins>
This sets the time that the Telnet interface can be idle before the switch
automatically logs out the user. The options are 2 mins, 5 mins, 10 mins,
15 mins, and Never.
Telnet Sessions (1..4) [1]
This sets the maximum number of available Telnet sessions.
88 IBM BladeCenter 4-Port Gb Ethernet Switch Module: Installation and User’s Guide
To Next Page
Loading...
