Complete the following steps to search for a particular MAC address:
Toggle the Browse By field to MAC Address.AMAC Address field will appear.
Enter the MAC address in the field and press Enter. Highlight BROWSE and press
Enter to initiate the browsing action. Highlight CLEAR ALL and press Enter to reset
the table counters.
Complete the following steps to search for a particular port:
Toggle the Browse By field to Port. The Module and Port fields will appear. Enter
the desired information in the respective fields and press Enter. Highlight BROWSE
and press Enter to reset the table counters.
Complete the following steps to search for a particular VLAN:
Toggle the Browse By field to VLAN.AVLAN field will appear. Enter the VID in the
field and press Enter. Highlight BROWSE and press Enter to initiate the browsing
action.
GVRP
To view the GVRP table, highlight GVRP on the Network Monitoring menu and
press Enter.
This read-only window displays Group VLAN Registration Protocol (GVRP)
information.
IGMP Snooping
This enables the switch IGMP Snooping table to be viewed. IGMP Snooping
enables the switch to read the multicast group IP address and the corresponding
MAC address from IGMP packets that pass through the switch. The ports where the
IGMP packets were snooped are displayed, indicated by an M. The number of
IGMP reports that were snooped is also displayed in the Reports field.
To view the IGMP Snooping table, highlight IGMP Snooping in the Network
Monitoring menu and press Enter.
Chapter 6. Configuring the switch module through the Telnet interface 95
To Next Page
Loading...
