Restarting the switch module
The switch module has several reboot (restart) options.
To restart the switch, highlight Reboot in the main menu and press Enter.
The reboot options are as follows:
Reboot
Restarts the switch. Any configuration settings that are not saved through
Save Changes in the main menu will be lost. The switch configuration will
be restored to the last configuration that was saved in NVRAM.
Save Configuration & Reboot
Saves the configuration to NVRAM (identical to using Save Changes) and
then restarts the switch.
Reboot & Load Factory Default Configuration
Restarts the switch using the default factory configuration. All configuration
data will be lost. This is identical to using Factory Reset and then Reboot.
Reboot & Load Factory Default Configuration Except IP Address
Restarts the switch using the default factory configuration, except the user
configured IP address will be retained. All other configuration data will be
lost.
A confirmation window will open.
Chapter 6. Configuring the switch module through the Telnet interface 97
To Next Page
Loading...
