IBM BladeCenter - Upload Configuration File; Save Log

The information on this window is described as follows:
Server IP Address
The IP address of the TFTP server.
Path and File Name
The full file name (including path) of the new firmware code file on the
TFTP server.
Upload Configuration File
The switch module current settings can be uploaded to a TFTP Server by the
switch module management agent.
Enter the IP address of the TFTP server in the Server IP Address field and the
complete path and file name of the firmware code file for the switch. Click Apply to
enter the server IP address into the switch RAM (select Save Changes to enter the
address into the switch NVRAM). Click Start to initiate the file transfer.
Note: If you do not save configurations to NVRAM, the configurations that you are
uploading to a TFTP server will not be saved correctly.
The information on this window is described as follows:
Server IP Address
The IP address of the TFTP server.
Path and File Name
The full file name (including path) of the new firmware code file on the
TFTP server.
Save Log
The switch module management agent can upload its history log file to a TFTP
server.
Note: An empty history file on the TFTP server must exist on the server before the
switch can upload its history file.
70 IBM BladeCenter 4-Port Gb Ethernet Switch Module: Installation and User’s Guide