- MIB-II (RFC 1213)
- 802.1P/Q MIB (RFC 2674)
- Interface MIB (RFC 2233)
- Mini-RMON MIB (RFC 1757) - four groups. The remote monitoring (RMON)
specification defines the counters for the receive functions only. However,
the switch provides counters for both receive and transmit functions.
– Supports Web-based management
– TFTP support
– Bootstrap protocol (BOOTP) support
– Dynamic host configuration protocol (DHCP) client support
– Password enabled
– Telnet remote control console
v Network cables:
– 10BASE-T:
- UTP Category 3, 4, 5 (100 meters maximum)
- 100-ohm STP (100 meters maximum)
– 100BASE-TX:
- UTP Category 5 (100 meters maximum)
- EIA/TIA-568 100-ohm STP (100 meters maximum)
– 1000BASE-T:
- UTP Category 5e (100 meters maximum)
- UTP Category 5 (100 meters maximum)
- EIA/TIA-568B 100-ohm STP (100 meters maximum)
Standards and topology
The following standards apply to the Ethernet switch module:
v IEEE 802.3 10BASE-T Ethernet
v IEEE 802.3u 100BASE-TX Fast Ethernet
v IEEE 802.3z Gigabit Ethernet
v IEEE 802.1Q Tagged VLAN
v IEEE 802.1P Tagged Packets
v IEEE 802.3ab 1000BASE-T
v IEEE 802.3x Full-duplex Flow Control
v ANSI/IEEE 802.3 NWay auto-negotiation
The following topology applies to the Ethernet switch module: Star
6 IBM BladeCenter 4-Port Gb Ethernet Switch Module: Installation and User’s Guide
To Next Page
Loading...
