13.32.6 Error reporting
The following table shows the values returned in the Status and Error Registers when specific error condi-
tions are encountered by a device.
10h or
01h
51h
The device is unable to write to its
Attribute Values data structure.
10h or
40h
51h
The device is unable to read its Attribute
Values or Attribute Thresholds data structure
04h51h
A S.M.A.R.T. FUNCTION SET command subcommand
other than S.M.A.R.T. ENABLE OPERATIONS was
received by the device while the device was
in a "S.M.A.R.T. Disabled" state.
04h51h
A S.M.A.R.T. FUNCTION SET command was re-
ceived by the device with a subcommand value
in the Features Register that is either
invalid or not supported by this device.
04h51h
A S.M.A.R.T. FUNCTION SET command was re-
ceived by the device without the required
key being loaded into the Cylinder High and
Cylinder Low registers.
Error
Register
Status
Register
Error condition
Figure 133. S.M.A.R.T. Error Codes
Travelstar 60GH & 40GN hard disk drive specifications
181
To Next Page
Loading...
