Notes:
1. Any connector that does not have a RIMM installed must have a continuity
RIMM (C-RIMM), a module that looks like a RIMM but has no memory on it.
A C-RIMM is used to continue the connection on a RIMM connector that does
not have memory installed.
2. Install only ECC RIMMs to enable ECC. If you use ECC and non-ECC memory
together, it will function as non-ECC memory.
3. RIMM connectors do not support dual inline memory modules (DIMMs).
4. Use only PC600 or PC800 RIMMs.
Note: If you use PC600 and PC800 RIMMs together, all memory will function
at the speed of the slowest RIMM.
5. Your IntelliStation M Pro computer supports 128 MB, 256 MB, and 512 MB
RIMMs. Your computer supports a minimum of 128 MB and a maximum of 2.0
GB of system memory. Go to http://www.ibm.com/pc/support for a list of
memory modules to use with your computer.
Note: The illustrations in this document might differ slightly from your hardware.
RIMM connector 1
RIMM connector 2
RIMM connector 3
RIMM connector 4
Retaining clip
Do the following to install a RIMM or C-RIMM:
Attention: When handling static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see “Handling
static-sensitive devices” on page 30.
1. Review the safety precautions listed in the “Safety information” on page 30.
2. Turn off the computer and all attached devices. Disconnect all external cables
and power cords; then remove the cover (see “Removing the side cover” on
page 30 for details).
3. Remove the support bracket.
Chapter 5. Installing Options 41
To Next Page
Loading...
