IBM Power PS700 Problem Determination And Service Guide

Table 14. B200xxxx Logical partition SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, “Parts listing, Type 8406,” on page 229 to determine which components are CRUs and which
components are FRUs.
B200 xxxx
Reference Code Description Action
B2001265 The partition could not start up. An
operating system Main Storage
Dump startup was attempted with
the startup side on D-mode, which is
not a valid operating system startup
scenario. The startup will be halted.
This SRC can occur when a D-mode
SLIC installation fails and attempts a
Main Storage Dump.
Correct the startup settings.
B2001266 The partition could not start up. You
are attempting to start up an
operating system that is not
supported.
Install a supported operating system and restart the
partition.
B2001280 A problem occurred during a
partition Main Storage Dump. A
mainstore dump startup did not
complete due to a configuration
mismatch.
Go to “Isolating firmware problems” on page 218.
B2001281 A partition memory error occurred.
The failed memory will no longer be
used.
Restart the partition.
B2001282 A problem occurred during the
startup of a partition.
Go to “Isolating firmware problems” on page 218.
B2001320 A problem occurred during the
startup of a partition.
No default load source was selected.
The startup will attempt to continue,
but there may not be enough
information to find the correct load
source.
Configure a load source for the partition. Then restart the
partition.
B2001321 A problem occurred during the
startup of a partition.
Verify that the correct slot is specified for the load source.
Then restart the partition.
B2001322 In the partition startup, code failed
during a check of the load source
path.
Verify that the path for the load source is specified
correctly. Then restart the partition.
B2002048 A problem occurred during a
partition Main Storage Dump. A
mainstore dump startup did not
complete due to a copy error.
Go to “Isolating firmware problems” on page 218.
B2002054 A problem occurred during a
partition Main Storage Dump. A
mainstore dump IPL did not
complete due to a configuration
mismatch.
Go to “Isolating firmware problems” on page 218.
Chapter 2. Diagnostics 31

IBM Power PS700 Specifications

General

Brand	IBM
Model	Power PS700
Category	Server
Language	English