Returning a device or component .....234
Removing the blade server from a BladeCenter
unit ................235
Installing the blade server in a BladeCenter unit 236
Removing and replacing Tier 1 CRUs .....237
Removing the blade server cover ......237
Installing and closing the blade server cover . . 239
Removing the bezel assembly .......240
Installing the bezel assembly .......240
Removing a drive ...........241
Installing a drive ...........242
Removing a memory module .......244
Installing a memory module .......245
Removing and installing an I/O expansion card 246
Removing a CIOv form-factor expansion card 247
Installing a CIOv form-factor expansion card 247
Removing a combination-form-factor
expansion card ...........249
Installing a combination-form-factor
expansion card ...........249
Removing the battery .........250
Installing the battery ..........251
Removing the disk drive tray .......252
Installing the disk drive tray .......253
Removing the tier 2 management card .....255
Installing the tier 2 management card .....256
Obtaining a PowerVM Virtualization Engine
system technologies activation code ......257
Replacing the FRU system-board and chassis
assembly ...............260
Chapter 5. Configuring .......263
Updating the firmware ..........263
Configuring the blade server ........264
Using the SMS utility...........265
Starting the SMS utility .........265
SMS utility menu choices ........265
Creating a CE login ...........265
Configuring the Gigabit Ethernet controllers . . . 266
Blade server Ethernet controller enumeration . . . 267
MAC addresses for host Ethernet adapters . . . 267
Configuring a RAID array .........268
Updating IBM Director ..........268
Appendix. Notices .........271
Trademarks ..............272
Electronic emission notices .........273
Class A Notices............273
Class B Notices............277
Terms and conditions...........280
iv Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)
To Next Page
Loading...
Need help?
General