IBM RS/6000 7043 43P Series - Page 136

Table 4-3 (Page 5 of 13). Firmware Checkpoints
Checkpoint
(hex)
Description Repair Action
E14C Create
terminal-emulator
node
See “Unresolved problems” on page 4-27
E14D Load boot image See “Boot Problems/Concerns” on page 4-28
E14E Create Client
Interface
node/dictionary
See “Unresolved problems” on page 4-27
E14F NVRAM validation,
config variable token
generation
See “Unresolved problems” on page 4-27
E150 Create host
(primary) PCI
controller node
See “Unresolved problems” on page 4-27
E151 Probe primary PCI
bus
1. Replace PCI Adapter(s)
2. Replace System Planar
See “Unresolved problems” on page 4-27
E152 Probe for adapter
FCODE, evaluate if
present
1. Replace PCI Adapter(s)
2. Replace System Planar
See “Unresolved problems” on page 4-27
E153 End adapter FCODE
probe/evaluation
See “Unresolved problems” on page 4-27
E154 Create PCI bridge
node
See “Unresolved problems” on page 4-27
E155 Probe PCI bridge
secondary bus
1. Replace PCI Adapter(s)
2. Replace System Planar
See “Unresolved problems” on page 4-27
E156 Create PCI ethernet
node
See “Unresolved problems” on page 4-27
E15A Create 64 bit host
(primary) PCI
controller node
See “Unresolved problems” on page 4-27
E15B Transfer control to
O.S. (Service mode
boot)
See “Boot Problems/Concerns” on page 4-28
E15C Probe primary 64 bit
PCI bus
See “Unresolved problems” on page 4-27
E15D Create host PCI
controller node
See “Unresolved problems” on page 4-27
E15E Create MPIC node See “Unresolved problems” on page 4-27
4-18 7043 43P Series Service Guide