Model 140 System Board Jumper Settings
For a more complete description of the function of these jumpers, see the system
unit User's Guide.
Jumper Description Settings
J15 Remote power-up Default: Remote power-up disabled.
To enable Remote power-up, place
jumper on two leftmost pins.
J21 Privileged-Access Password Default: disabled.
To enable the writing or changing of
the privileged-access password, place
jumper on the two leftmost pins.
J28, J31,
J32, J34
SCSI Security Default: external SCSI enabled
To disable external SCSI connector,
remove the jumpers from J31, J32, and
J34; move the jumper on J28 to the to
the front two pins.
J90 Power-On Password Default: power-on password enabled
(can be set).
To disable the power-on password (for
instance, if it has been forgotten), place
jumper on the two rightmost pins.
Chapter 1. Reference Information 1-11
To Next Page
Loading...
