System Board
Removal
1. If you have not already done so, remove the covers as described in “Cover” on
page 8-3.
2. Do the removal procedure under “Adapter” on page 8-19.
3. Do the removal procedure under “Riser Card” on page 8-37.
4. Disconnect all cables from the system board.
5. Do the removal procedure under “Memory Modules” on page 8-20.
6. Do the removal procedure under “Processor Card (for the Model 240)” on
page 8-24.
7. Remove the screws from the system board.
8. Lift the system board out of the system unit.
8-28 7043 43P Series Service Guide
To Next Page
Loading...
