Step 1540B-10
The system is working correctly with this configuration. One of the FRUs (adapters)
that you removed is probably defective.
1. Turn the power off.
2. Install the second processor card if one was removed. If a second processor was
not removed, or has already been reinstalled and verified, install a FRU (adapter)
and connect any cables and devices that were attached to it.
3. Turn the power on.
4. If the Console Selection screen is displayed, choose the system console.
5. After the keyboard indicator is displayed, press the F5 key on the
directly-attached keyboard or the number 5 key on an ASCII terminal keyboard.
6. Enter the appropriate password when prompted to do so.
Is the "Please define the System Console" screen displayed?
NO Go to “Step 1540B-11” on page 2-49.
YES Repeat this step until all of the FRUs (adapters) are installed, then go to
the Repair Checkout Procedure in the Diagnostics Information for Multiple
Bus Systems.
2-48 7043 43P Series Service Guide
To Next Page
Loading...
