Figures
1. Front View of the IBM SAN48C-6 Switch......................................................................................................2
2. Rear View of the IBM SAN48C-6Cisco MDS 9148T Switch Switch..............................................................2
3. Side View of the IBM SAN48C-6 Switch....................................................................................................... 3
4. IBM SAN48C-6 Fan Module.......................................................................................................................... 4
5. IBM SAN48C-6 PSU.......................................................................................................................................4
6. Installing the Shelf Bracket Kit into a Telco Rack.......................................................................................12
7. Installing the Shelf Bracket Kit into an EIA Rack....................................................................................... 13
8. NEBS Kit for 2-Post Installation..................................................................................................................16
9. NEBS Kit for 4-Post Installation..................................................................................................................17
10. Installing Rack-Mount Brackets on the Front Side of the Chassis...........................................................19
11. Installing Rack-Mount Brackets on the Front Side of the Chassis...........................................................22
12. Installing the Switch onto the 2-Post Rack From the Front Side of the Chassis.....................................23
13. Installing the Switch onto the 2-Post Rack From the Rear Side of the Chassis......................................24
14. Grounding the Switch................................................................................................................................25
15. Wearing the ESD Strap..............................................................................................................................26
16. Handling the Chassis.................................................................................................................................27
17. Connecting an LC-Type Cable to a Fibre Channel Port.............................................................................33
18. RJ-45 Interface Cable Connector.............................................................................................................48
19. Twisted-Pair 10/100/1000 BASE-T Cable............................................................................................... 48
20. Twisted-Pair 10/100 BASE-T Cable Schematic....................................................................................... 49
vi
To Next Page
Loading...
