IBM SurePOS 700 Series Hardware Service Guide

3. Turn off the machine.
4. Continue with the steps described in “Replacing and rebuilding a hard disk drive
(Models xx4).”
Replacing and rebuilding a hard disk drive (Models xx4)
Note: Before beginning these procedures, complete one of the two methods to
determine the failed hard disk drive.
Follow the steps in the “Replacing a hard disk drive” on page 38 to remove and
replace the failing hard disk drive.
After the operating system loads, the RAID application rebuilds the hard disk drive
automatically. During this process, you can use the machine normally. Rebuilding
time varies depending upon the size of the partition, the amount of data, and the
system activity during the rebuild. See Figure 50 on page 70.
Figure 49. Boot up warning
Chapter 3. Problem determination 69

IBM SurePOS 700 Series Specifications

General

Brand	IBM
Model	SurePOS 700 Series
Category	Touch terminals
Language	English