IBM SurePOS 700 Series Hardware Service Guide

Figures
1. Example of the wide and narrow SurePOS 700 Series .................1
2. 2 G configuration DIMMs ............................5
3. 4 G configuration DIMMs ............................6
4. 8 G configuration DIMMs ............................7
5. Front panel controls and indicators ........................11
6. Front panel of Models 743, C43, E43, 783, E83, 784, C84, and E84 ............12
7. Rear panel .................................13
8. Base configuration ..............................14
9. RS-232 and base configuration .........................14
10. RS-485 and base configuration .........................15
11. USB and base configuration...........................16
12. Uninterruptible power supply rear view .......................20
13. Location of uninterruptible power supply configuration switches ..............21
14. Setting the cash drawer using the jumper override ..................22
15. Location of the printer jumper on the I/O card ....................23
16. Example of the powered uninterruptible power supply port ...............24
17. Serial number and machine information on front and bottom ...............27
18. Installing two mounting tabs into the slanted I/O tray..................30
19. Removing the front bezel ............................31
20. Opening the rear door .............................33
21. Removing the top cover ............................34
22. Installing the top cover.............................35
23. Placement of bezel ..............................36
24. Removing the unit pullout tray from the unit frame ..................37
25. Removing a hard disk drive ...........................38
26. Removing an optical drive ...........................39
27. Opening the I/O module latch ..........................40
28. Removing the I/O module latch .........................41
29. Disconnecting the chassis fan ..........................42
30. Removing the chassis fan with duct ........................43
31. Processor fan and levers ............................44
32. Removing feature cards ............................46
33. Loosening the spline screw ...........................47
34. Loosening the spline screw ...........................48
35. Removing the riser screws ...........................49
36. Removing the riser battery ...........................50
37. Removing the DASD cage ...........................51
38. Removing the system board tray .........................53
39. Removing the system board battery (Models xx3) ...................54
40. Replacing the Model xx4 battery .........................55
41. SurePOS 743 and 783 system board .......................56
42. SurePOS 723 system board...........................57
43. System Event Log Viewer screen .........................61
44. Example of saved events screen .........................62
45. Disk drive failure ...............................65
46. Boot up warning ...............................66
47. Example of the RAID setup menu ........................67
48. Viewing the hard drive and volume status......................68
49. Boot up warning ...............................69
50. Example of the RAID setup menu ........................70
51. Location of CMOS jumper - Models 743, C43, E43, 783, and E83.............73
52. Location of CMOS jumper - Models 723 and E23 ...................74
53. Location of CMOS jumper - Models 784, C84, and E84 ................74
© Copyright IBM Corp. 2007, 2010, 2012 ix

IBM SurePOS 700 Series Specifications

General

Brand	IBM
Model	SurePOS 700 Series
Category	Touch terminals
Language	English