Installing a CD or DVD drive
To install a CD or DVD drive, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 7.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
3. Remove the side cover (see “Removing the side cover” on page 10).
4. Remove the two-piece bezel (see “Removing the two-piece bezel” on page
11).
5. Use a screwdriver to pry the EMC shield away from the server.
Note: If you are installing a drive that contains a laser, observe the following
safety precaution.
Chapter 2. Installing optional devices 17
To Next Page
Loading...
